Probe Function Question

DWeaver

I purchased a corner probe that is triangular, and I have been working on the setting to get the probe function to work on the controller...

Controller  Setting Number	Setting	What it does
#68	3	Puts the  controller into probing mode #3
#2000	?	The diameter  of the probe tip (I put in for 1/8th inch endmill)
#2001	8.06	Tool plate  thick for X
#2002	7.77	Tool plate  thick for Y
#2003	3.6	Tool plate  thick for Z
#2004	-20	shift of X  axis before probed
#2005	50	shift of Y  axis before probed
#2006	5	Z position  before X(Y)-axis probed
#2007	5	Back distance  when the tool touches the X-axis edge
#2008	5	Back distance  when the tool touches the Y-axis edge
#2009	5	Back distance  when the tool touches the Z-axis edge
#2010	?	center of  tool plate
#2011	?	Probe  feedrate

I am not sure if the ones I have filled in are right, and I cannot figure out the ones with the question mark.


#2000 - shouldn't this depend on what size endmill I am using?
#2010 - This just makes zero sense at all to me, not sure why the center of the probe plate is important.
#2011 - it indicates that this is in relation to "G01 command in relative (G91) mode" - not sure what that means.. I think that 3mm/sec should be fast enough to start, and I can speed up or slow down from there.

Could anyone please look at the attached image of my probe (with all the measurements as well as the discussion of where I want to place it) and let me know if these settings I have are right and what I should put into the settings I do not have.

Thank you very much to anyone who responds...

Daniel