Screen displays "starting" and does nothing else after update

hhinman

we purchased the DDSC-Expert Standalone Motion Controller (5 axis). It was booting up fine. We followed instructions to update and after doing such, whenever we power on the screen simply displays "starting" and never changes (let it run overnight even0. I saw a post where an admin provided someone an "install.rar" file to place on a USB and boot to reset. Same issue - it just displays "starting'. How do we rest and get past this please?

amen20065

V1.zip

The store with Ali Express "Shop910724082 Store" helped me
he sent me a file with the V1 firmware version (V1.zip) by email

1: Copy the install folder to an empty USB drive
2: Insert the USB drive, restart the system and wait for it to automatically start up;

I downloaded the install folder to a flash drive and inserted it into the USB slot, after rebooting everything became ok

http://www.ddcnc.com/?m=home& ... tid=101&lang=en
(maybe he took it from here)

Hi, My friend
Welcome to my shop, what can I do for you?
You can leave me a message or contact me by
My Email: kkcnc888@163.com
My WeChat ID：L941124924
My WhatsApp ID：+86 18320919675
If you need to order in large quantities, please leave your email ID or Whatsapp ID for contact, or you can find me through the above contact information.
Have a good day.