|
Hello!
I bought a DDCSV1.1 controller, I made the connections to the drivers with motors and power supply, without connecting the Switches
But, it has some problems:
- on the 3 axes, at the value of 204,800 mm there is a threshold, when it decreases by 0.01 mm, it jumps on the X axis to 3421773, and on the Y and Z axes to 409.594 and when it moves by 0.01 mm on the plus, it reaches again 204,800 and grows normally to 409.594.
- When I want to start working on a file, after Play, Reset is activated immediately, without doing anything else.
I checked and deactivated the working limits.
I installed the latest version of Firmware, from 2020-03-06.112 and the X-, X +, Y-, Y + keys for selections no longer worked.
After a few tries, I reintroduced a firmware from 2018-07-30-98.
But the problems with the limits and the Play function remained.
I installed the version of Firmware 2019-04-25-107, now the X-, X +, Y-, Y + keys for selections no longer worked, again and now i can't install any other firmware.
Is it possible to delete all previous folders and settings and install only one firmware?
I mention that I also have a DDCSV3.1 Controller, which I use and it works very well and I am very satisfied with it.
Please advise me what to do. Thank you in advance!
|
|