|
Last edited by Bpinv In 2019-7-8 17:42 Editor
Hello.
I reinstalled the software. Problem still exists. At high speed (F = 1500 mm/min) draws closed regular circles. At low speeds (F = 100 mm/min) , the laser path is irregular. For some reason, on the arcs the direction of movement of the laser changes and instead of a circle a strange figure is obtained. Draws straight lines correctly at any speed. I attach the photo again: work with the same nc-code at different speeds. |
-
tr.jpg
(398.65 KB, Down times: 733)
|