G-Code sample available?

StefanS

Hi all,

I´m overhauling a small 4-axis mill in the moment and bought the DDCS V3.1-controller for this purpose. On my last machine (just a 3-axis build by my own) I´m using LinuxCNC in the moment.

Is there a sample NC-file existing where I can have a look and see the rules? My daily job is to develop postprocessors and machine simulations for Siemens NX so when I start a project I normally have a sample code snippet where I can see the naming rule of the NC-file, the standard start sequence, the end sequence and so on. I know some controlles are critical and need special characters at the start or the end (I don´t mean a M30). I don´t ask for an explanation of every command, I saw the list in the controller documentation.


Can someone share a file or post a normal start and end sequence in here?

Thank you in advance
StefanS

AndreyB

Hi.

I just start using DDCSv3.1, but maked few parts with this gcode.

StefanS

Hello Andrey

Looks quiet close to Fanuc.

Thank´s a lot

StefanS