|
|
hello. i got a v3.1 on a lathe and mill upgrades and use fusion 360 hobby license and having troubles with my post processors. only two processors on the entire fusion family support ddcs4 controller with .gc file. and none at all for turning.
someone kind enough to offer solutions on how to find or make a post-processor for turning with this controller. whenever I post codes with .nc file extensions never work with this controller as it turns the axis in opposite directions until they fall off if not stopped.
have had little success with 2 post-processors on fusion that give .gc file extensions that sometimes work fine others just work out completely different stuff from expectations.
regards
|
|
Posted at 2021-7-14 18:31:44
Favorite