how to use tool offsets?

ghall · Posted at 2021-7-9 04:14:54

g code T1 does not select tool 1. How do you get it to use the tool offset table?

weitling · Posted at 2021-7-31 14:02:14

I have the same problem I think that the M6 T2 is calling the subrutine TC.NC but that is in chinese and is not been running when i call tool change with M6. If i use the TAB button and go to T0 and i try change to T1 it just ignore it and return to T0

Ivan_Britt · Posted at 2021-9-2 21:46:11

Для использования компенсации длины и радиуса нужно применять нужный код (G43 и номер ячейки компенсации), прописывается в управляющей программе. Почитайте инструкцию, там всё написано.

AdaDDream · Posted at 2021-9-13 14:23:21

Hope this could help you

AdaDDream · Posted at 2021-9-13 14:47:48

Hello,DDCS V3.1 does not have tool offsets function,I am so sorry for your trouble.

how to use tool offsets?

TEL

0755-87654321