Full list of DDCSV commands

Palavan · Posted at 2019-6-3 20:16:06

Perhaps guilty firmware?
Now I have 2019-04-25-107
Did you have something like that?

Palavan · Posted at 2019-6-3 20:17:46

Prompt stable firmware.
Another question is it possible to start processing with a specific line, as in MACH3

ytliu · Posted at 2019-6-3 20:20:03

Last edited by ytliu In 2019-6-3 20:22 Editor

Please check the 24V power supply. The DDCS has a power monitoring module. Usually, the external power supply is lower than 18V, and the system will automatically turn off. At this time, the buzzer will beep until you turn off the power.

Palavan · Posted at 2019-6-3 21:02:31

Thanks for the quick response, I also thought about the problem with the power supply, I will replace the other day

yaddatrance · Posted at 2019-6-3 22:02:07

Palavan Posted at 2019-6-3 20:17
Prompt stable firmware.
Another question is it possible to start processing with a specific line, as ...

To start a job from a given line, press [2nd/Shift] button, then press [Start] which will ask you what line to start on, use [left/right arrow] to choose the digit and [up/down arrow] to change the digit. When finished, press [Enter/Z-] to start running. If your code is long, it may take minutes to process before cutting. The example I was given says 15 minutes to resume from line 600,000.

Full list of DDCSV commands

TEL

0755-87654321