extkey1.nc

Belwect

Hello everyone. I created a file extkey1.nc to warm up the spindle. What should I do to make this file run when an external button is clicked?

ShaniaDDream

Hi Belwect, what kind of extkey1.nc is it? Can you send it to our technical department sky@ddcnc.com? Our technical person will check and test it and then tell you the results.

Belwect

Thanks. I figured it out myself. Maybe someone will need it. File extkey1.nc you need to put it in the internal memory of the controller, and when you press the external button, it will start.

felipe

what is the idea behind extkey1.nc and 2?  (Create a g executable code add on the pendrive a folder called extkey1.nc inside the root directory “install” when inserting in the controller it will take it for you and so with the external button it will run the code, can you confirm if this is so?

Belwect

Yes, that's right.

cico0815

Hi.

Where can I find such information about the .nc files? Is there some doc to read?

Thank you.

Best regards,

Heiko