Metric/imperial parameter#115

ianj

Hello. I've just purchased DDCS4 V3.1 with ver 2020-03-06-112NOR firmware loaded. I bought this because "the new features " state the unit is compatible with metric and imperial units.In the user manual v3 page 72 parameter #115  0=mm and 1=inch, but when I go to parameters on the unit #115 does not appear in the list.

ShaniaDDream

You need to press " page R“  to store the setting  and then reboot the controller, after that you can use the imperial units .

ianj

Hello Shania.
Thank you for your reply. My problem is I cannot find #115 on my controller.The manual shows 12 system setting parameters including #115. On my controller in system settings there are 13 items including #120 & #2039 which are not mentioned in the manual but NO #115.
  Is #115 in system settings on your controller?
Thank You.

ShaniaDDream

Mine is also ver 2020-03-06-112NOR. You find them in the wrong place, when you press "Page R", the first column is -----【Top parameters] listed as below, and the fourth line , that 's it.
5.  minimum radius of 4 axis machine
6.  A axis rotate reference axis
104.   A axis optimal path when GO run
115  Unit selection       mm----- here is it

I know what you are talking about, you are going to the column under it. The column name is -----【system settings】， it has 13 items including the new features #120 and #2039 that are not listed in our manual, because the manual has been updated yet.

You can try it again, hope it helps.

ianj

Hello Shania.
Thank you very much for your answer. Problem now solved.