Still trying to upload

alexwalex

Первичное смещение по x задается #2004, после нахождения 0 по X щуп выходит ро  X в координату #2010, затем отходит по Y на #2005 и замеряет Y.

Will_D

The user sets the initial Y position before starting the probe so its only X that needs #2010.

Пользователь устанавливает начальную позицию Y перед запуском зонда, поэтому его единственный X, который нуждается в # 2010.

Nikolay81

Will_D Posted at 2018-9-10 23:54
The user sets the initial Y position before starting the probe so its only X that needs #2010.

По ...

Thank you. I understood what your idea is. But it seems to me that it is much more convenient to immediately set the tool, with the X and Y axes offset and not only the Y axis.
Since, the tool will be too close to the edge of the sensor and it is likely that when Z is lowered, it may miss the sensor.
Perhaps, it will be convenient for someone.
I think you should make a video about the usefulness of the parameter # 2010.

DWeaver

This is an old post that I have been reading through to find answers about the probing functionality, but still unsure of some of the settings.

I want to set my probe up in the controller.  I purchased a corner probe that is triangular, and I have been working on the setting to get the probe function to work on the controller...

#68 - 3 - Puts the  controller into probing mode #3
#2000 - ? - diameter of probe
#2001: 8.06mm - Tool plate  thick for X
#2002: 7.77mm - Tool plate  thick for Y
#2003: 3.6mm - Tool plate  thick for Z
#2004: -20mm - shift of X  axis before probed
#2005:  50mm - shift of Y  axis before probed
#2006:  5mm - Z position  before X(Y)-axis probed
#2007:  5mm  - Back distance when tool touches X-axis
#2008:  5mm - Back distance when tool touches Y-axis
#2009:  5mm  -Back distance when tool touches Z-axis
#2010:  ?  -  center of  tool plate
#2011:  ?  Probe feedrate

I am not sure if the ones I have filled in are right, and I cannot figure out the ones with the question mark.
#2000 - shouldn't this depend on what size endmill I am using?
#2010 - This just makes zero sense at all to me, not sure why the center of the probe plate is important.
#2011 - it indicates that this is in relation to "G01 command in relative (G91) mode" - not sure what that means.. I think that 3mm/sec should be fast enough to start, and I can speed up or slow down from there.