Firmware download

ytliu

Ver:2018-10-09-101 Description:
1. On the file and parameter page, you can operate through the handwheel;
2. Increase #2031 uniaxial acc is limited by M_Ctrl start acc;
3. Increase #2030 Soft-limited stop mode;
4. Increase #2029 color reversal;

ytliu

You can modify the configuration file.

If your language is English, open eng with Notepad and find this line.
#224 -t1 -s1"Spindle M3/M4/M5 response Duration" -s2"s" -m6 -min=0.000 -max=9.000
Change 9.000 to 20.000, then reinstall eng into the controller

ytliu

Thank you, I will modify it.

ytliu

Hi Stein,
First of all, I want to know if you have successfully upgraded. For example, if you upgrade using install(2019-06-10-111).zip, after the upgrade is successful, Ver:2010-06-10-111NOR will be displayed in the lower right corner of the screen.

Wlod

Hello everyone!!
writes by google translator
because I am from Poland.
I have DDCSV1.1 with an update
2018-10-09-101
a serious problem with reading the hole code, e.g.
of these holes made, the contour is made normally and the other enters with a milling cutter without a contour at full depth.
I generate paths from mastercam x3. Regards and please help

Xyem_no_ctoly

Здравствуйте,если я хочу оставить свою прошивку на контроллере но нужно мне изменить язык интерфейса как мне поступить где и какой файл куда вставлять,заранее спасибо