|
|
Hello!
We are using DDCSV 3.1 on big steel CNC milling machine and a lot of work we can do without CNC using manual mode to do simple operations.
Typically we need rapid moves and work cutting feed rate in manual mode. Cutting steel typically need very low feed rates.
We set maximum manual feed rate to have a rapid moves and on 20% we have too fast speed to cut steel.
But we can not set lower than 20%, it has software limited.
How can we avoid this limit?
Thank you!
|
|
Posted at 2020-4-20 02:32:42
Favorite