How to achieve the correct tool change! on the DM500 controller

coolrool

Pri primenenii komandy M6T3 kontroller obrashchayetsya k faylu T.nc no ne peredayet v nego parametr #593. A takzhe pri vybore instrumenta iz glavnogo menyu stanka smeny nomerainstrumenta ne proiskhodit. Kto znayet v chem problema? YA nastroil smenu cherez komandy M501, M502, M503... no eto ne pravil'no.  Kto znayet v chem problema i kak yeye reshit'?
When using the M6T3 command, the controller accesses the T.nc file but does not pass parameter #593 to it. Also, when selecting a tool from the main menu of the machine, the tool number does not change. Who knows what the problem is? I configured the shift using commands M501, M502, M503... but this is not correct.  Who knows what the problem is and how to solve it?