DDCSV3.1 software bug fixes

Ghost-51 · Posted at 2019-7-14 00:52:48

ytliu Ver:2019-07-13-111 Description:
1. Add configuration item #2042:whether all-zero op. contains the Z-axis;

Thank you, have not yet installed.
Is it for 4 axis controller?
It may be better to add a paragraph in the menu and leave it as it was in previous versions (Shift + 2 * -X), is there such an opportunity?

Ghost-51 · Posted at 2019-7-14 01:43:00

ytliu · Posted at 2019-7-14 06:19:15

The installation package provided on the forum is applicable to DDCSV2.1-3.1.
If your controller is DDCSV1.1 and the firmware version number ends with NOR, you can use the installation package in the forum to upgrade.

DDCS three-axis and four-axis applications are the same, and it automatically recognizes hardware information.However, their configuration files (eng,chs,rus) are different. The firmware installation package on the forum uses a 4-axis configuration file, so there is no problem installing it on a three-axis controller.

ytliu · Posted at 2019-7-14 10:32:18

When #2042=1, this firmware will pop up a dialog window during all zero operation.

Ghost-51 · Posted at 2019-7-14 11:44:08

Thank you, we will install and proto-process on Monday

Ghost-51 · Posted at 2019-7-16 01:54:47

Last edited by Ghost-51 In 2019-7-16 02:13 Editor

Install the firmware, # 2042 = 1 или 0, Z axis goes to 0Video https://yadi.sk/i/zWj8n7tO_fLS-Q

ytliu · Posted at 2019-7-16 05:38:26

I'm sorry, I misunderstood.I have modified the relevant part in slib.nc, please install it.

Ghost-51 · Posted at 2019-7-23 01:54:29

Last edited by Ghost-51 In 2019-7-23 01:56 Editor

Thanks, it works as it should.But there are bugs, I will observe - I will unsubscribe

bolek · Posted at 2021-5-7 08:08:57

Hello all, I have ddcsv2.1 but on-screen say ddcs3v2.1 .I have it unused for a while. The old cutting toy went to the garbage because of the worn and parallel port. I made a new frame and decide to use ddcsv. All works great but don't have all limit switches I use a proximity sw. Working on the proper motor setup I decided to test run circle. Now I see every time the tool gets to the beginning of the circle the machine stop and waits for the controller to catch up. I try different G codes and screw with configuration. Now I know that I have to download G codes into ddcsv. The problem is that I don't have the imperial measurement, no more, only metric. No matter if I change it in config it shaw in. but the value is in mm.
What did I do, help, please

DDCSV3.1 software bug fixes

TEL

0755-87654321