With the latest firmware(2018-09-07-100).zip), the following happens.
Start program, and hit the FRO button to adjust the feed rate. Controller locked up. Locked up & could only reboot to clear it.
maxx2000 Posted at 2018-9-21 22:56
With the latest firmware(2018-09-07-100).zip), the following happens.
Start program, and hit the FR ...
I found the reason for this error, because #2028 is a new parameter, after the installation is complete, #2028=0, you need to reset this parameter, such as 10.
HI everybody! Thanks for support and improving the device!
Is there somebody faced the trouble - in program (AUTO) mode when G0 command starts(for ex. G0 Y1000) Y axis sometimes misses steps and motor stops, however in the manual fast moving mode(CONT) it was never happened.The speed limits are set the same - 2800mm/min and acceleration/stoping also the same - 40mm/sec2 for both manual and program modes. X and Z axis are working normally.
Dear Ytliu, if it possible can you comment these sections of setting(Motor parameters) please !
It may be I did somthing wrong but when I used Mach the CNC worked right.
По-моему, твой перевод тоже немного корявый.
Посмотри новый перевод - так будет лучше?Ещё в переводе есть места, которые можно более понятно назвать, по твоему мнению?
Насчёт "всё ОК" - это ты зря. Перевод, довольно корявый. Просто у меня больше нет времени им заниматься.
Я пожилой станочник, в "этих ваших Интернетах" плохо разбираюсь.
А ты - молодой и активный. Может, создашь тему на профильных форумах о улучшении перевода?
Коллективный разум, сможет этот перевод улучшить. Если захочет :-)
Корявый??? Ты наверное не видел перевод Fanuk-а - вот это корявый перевод, стыдно должно быть японцам.
Сложно перевести точно и понятно, когда ограничено количество символов. Мне кажется текущей версией перевода вполне можно пользоваться, а кого не устроит - сам сможет подправить под себя.