CONTROLLER NOT READING G CODE

2Fabricate

Hello,

I built Bulkman Ultimate Bee router, everything seems to work and light up, the controller homes without any problems but when i try to send gcode it moves Z axis up slightly and stops while beeping continuously. tried multiple file formats, .NC .GC .TAP .Gcode. tried multiple post processors, from fanuc and mach3 to the most basic default post processor in rhinocam but nothing seems to solve the problem, it does the same thing when i try to probe. looking for any kind of help to make the controller read gcode

Thanks

AndreyB

DDCS v3, before running you gcode, calls /mnt/nand1-1/safez.nc
by default safez.nc has weird content

I know two ways to fix it:
1) rename or delete /mnt/nand1-1/safez.nc to disable it (i'm use this solution)
2) edit content /mnt/nand1-1/safez.nc for your needs