Modify go up z axis - DDCSV3.1 Standalone CNC Motion Controller - Digital Dream Technology support
View: 3036|Reply: 1
Print Previous Topic Next Topic

Modify go up z axis

[Copy Link]

3

Threads

5

Posts

55

Credits

Registered member

Rank: 2

Credits
55
Jump to the specified floor
Landlord
Posted at 2021-1-10 07:32:30 | Only Author Replies reward |Descending browser |Read mode
Last edited by Xartan In 2021-1-10 07:33 Editor

Hello


I have a 3.1 panel.

When I execute a gcode in the panel 3.1, the Z axis, goes up 40mm and then goes back down to the start position of the job correctly.

My question is...

- Is it possible to modify it so that it does not go up to 40mm and that it goes up to 20mm the Z axis at the beginning of the job?

DDCSV3. 2DDREAM
SEE: 2019-09-18-112NOR

Thank you
Reply

Use props Report

0

Threads

61

Posts

200

Credits

Intermediate Member

Rank: 3Rank: 3

Credits
200
Sofa
Posted at 2021-3-15 14:09:44 | Only Author
Please check #82 ( page 66), whether you have  set the value here 40mm, perhaps you can change it to 20mm. You can try it first .
Reply Support Opposition

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list