Metric/imperial parameter#115 - DDCSV3.1 Standalone CNC Motion Controller - Digital Dream Technology support
View: 3744|Reply: 4
Print Previous Topic Next Topic

Metric/imperial parameter#115

[Copy Link]

1

Threads

3

Posts

37

Credits

Newbie Member

Rank: 1

Credits
37
Jump to the specified floor
Landlord
Posted at 2021-4-25 03:02:38 | Only Author Replies reward |Descending browser |Read mode
Last edited by ianj In 2021-4-25 03:32 Editor

Hello. I've just purchased DDCS4 V3.1 with ver 2020-03-06-112NOR firmware loaded. I bought this because "the new features " state the unit is compatible with metric and imperial units.In the user manual v3 page 72 parameter #115  0=mm and 1=inch, but when I go to parameters on the unit #115 does not appear in the list.
Reply

Use props Report

0

Threads

61

Posts

200

Credits

Intermediate Member

Rank: 3Rank: 3

Credits
200
Sofa
Posted at 2021-4-26 11:41:28 | Only Author
You need to press " page R“  to store the setting  and then reboot the controller, after that you can use the imperial units .
Reply Support Opposition

Use props Report

1

Threads

3

Posts

37

Credits

Newbie Member

Rank: 1

Credits
37
Bench
 Author| Posted at 2021-4-26 20:55:10 | Only Author
Last edited by ianj In 2021-4-26 22:40 Editor

Hello Shania.
Thank you for your reply. My problem is I cannot find #115 on my controller.The manual shows 12 system setting parameters including #115. On my controller in system settings there are 13 items including #120 & #2039 which are not mentioned in the manual but NO #115.
  Is #115 in system settings on your controller?
Thank You.
Reply Support Opposition

Use props Report

0

Threads

61

Posts

200

Credits

Intermediate Member

Rank: 3Rank: 3

Credits
200
Floor
Posted at 2021-4-27 08:40:35 | Only Author
Mine is also ver 2020-03-06-112NOR. You find them in the wrong place, when you press "Page R", the first column is -----【Top parameters] listed as below, and the fourth line , that 's it.
5.  minimum radius of 4 axis machine
6.  A axis rotate reference axis
104.   A axis optimal path when GO run
115  Unit selection       mm----- here is it

I know what you are talking about, you are going to the column under it. The column name is -----【system settings】, it has 13 items including the new features #120 and #2039 that are not listed in our manual, because the manual has been updated yet.

You can try it again, hope it helps.
Reply Support Opposition

Use props Report

1

Threads

3

Posts

37

Credits

Newbie Member

Rank: 1

Credits
37
5#
 Author| Posted at 2021-4-27 15:31:06 | Only Author
Hello Shania.
Thank you very much for your answer. Problem now solved.
Reply Support Opposition

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list