Hello, I tried to drive a lathe with DDCS, it works fine

leo121 · Posted at 2021-10-25 06:26:03

Last edited by leo121 In 2021-10-25 06:27 Editor

Hello, I tried to drive a lathe with DDCS, it works fine, ok there is no spindle feedbak for thread, I hope to change a firmware in the future so that you get an input for the spindle.

https://vimeo.com/638450158
https://ibb.co/gmgMGKK

AdaDDream · Posted at 2021-10-25 15:21:53

Thank you!

Hello, I tried to drive a lathe with DDCS, it works fine

TEL

0755-87654321