Z Axis Change its position after breakpoint - DDCSV3.1 Standalone CNC Motion Controller - Digital Dream Technology support
View: 2446|Reply: 1
Print Previous Topic Next Topic

Z Axis Change its position after breakpoint

[Copy Link]

1

Threads

1

Posts

5

Credits

Newbie Member

Rank: 1

Credits
5
Jump to the specified floor
Landlord
Posted at 2021-9-2 02:04:33 | Only Author Replies reward |Descending browser |Read mode
Hello.
I've notice a strange situation on Z Axis.
I press SHIFT + Pause to create a breakpoint to continue my work next day.
When I restart the work, I press Pause button to restart the process from last point.
But on my work I"ve noticed that Z Axis is about 0.5 mm down from it's original position and the work shows an irregularity on Z Level.

This not happens when I pause the process (pressing PAUSE) and restarting after sometime. In this case, I do not turn off my CNC and DDCS.

Somebody had this issue?

Regards.
Reply

Use props Report

1

Threads

28

Posts

131

Credits

Registered member

Rank: 2

Credits
131
recommend
Posted at 2021-9-2 19:56:55 | Only Author
Turn off machine
Put your hand on the Z axis
Try moive it down (be carefully!)
If the force to move is small, this can be problem.

In any case, restarting the job (after turn off machine) without fixing the coordinate system is a bad idea.
Reply Support 1 Opposition 0

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list