imperial measurement

bolek

Hello all, I have ddcsv2.1 but on-screen say ddcs3v2.1 .I have it unused for a while. The old cutting toy went to the garbage because of the worn and parallel port. I made a new frame and decide to use ddcsv. All works great but don't have all limit switches I use a proximity sw. Working on the proper motor setup I decided to test run circle. Now I see every time the tool gets to the beginning of the circle the machine stop and waits for the controller to catch up. I try different G codes and screw with configuration. Now I know that I have to download  G codes into ddcsv. The problem is that I don't have the imperial measurement, no more, only metric. No matter if I change it in config it shaw in. but the value is in mm.
What did I do, help, please

ShaniaDDream

No matter if I change it in config it shaw in. but the value is in mm.--- Do you store the setting and then restart the machine?

bolek

I do store the setting and going to restart

bolek

Okay, I did it, I saved config in inches and restarted the unit. Nope, it shows inch but measuring in mm. Is it possible that I erased or change some config file?

ShaniaDDream

If so, please send email to jessy : info@ddcnc.com for help. In case of  any misoperation, please do not erase or change some config file before  you asked jessy.

bolek

Hello, I did email Jessy at info@ddcnc.com  while ego, unfortunately, no return message received
any other suggestions?

ShaniaDDream

Hi, when you choose "the imperial measurement", you need to configure your step equivalences the same as "the imperial measurement", or not, it is meaningless.