add a function to wait for an input signal

Franklin

Hi, can you add a function to wait for an input signal, like M66 in linuxCNC?M66 wait on an input stops further execution of the program, until the input to go to the HIGH state.I think need to use unused sensors for example a home or other.
It's real to do this? Thanks.

ShaniaDDream

DDCS-Expert can supply the function you need. You can self-define the G or M code, for any commands you need.

Franklin

It would be useful to do this on DDCSV3.1, I made about 10 machines with this controller and I really need such a function. Can you make such a firmware?

ShaniaDDream

If you insist on using DDCS V3.1, you can do customized service in our factory, because it is a secondary software.