HELP. It does not run G codes.

Enfama

I am not able to get it to run any G commands.
I load a file with G commands and when I press the "Start" key, the Z axis starts subri until it reaches the end of the stroke and crashes with the error sound.
It is not capable of executing a single simple line, for example: G0 X10 Y10 and the Z axis is always activated until reaching the end of the stroke. Even though the line does not refer to the Z axis.
Can anyone help this newbie to fix the problem ??

Enfama

Ok. I have been reading the forum and have found the solution. The problem was at a very high value at # 82.