Датчики

Frost

Поддерживает лиCNC Motion Controller DDCS V3.1 датчики PNP NC, как их подключить

JessyChen

DDCS V3.1 не поддерживает PNP, поддерживает только тип NPN.
DDCS V3.1 don't support PNP, only support NPN type.

DZiK

I'll take a look tomorrow.
The panel supports my positive probe and a negative Z height sensor in one slot without switching settings.
The panel is galvanically isolated, you can just try if it works or not.

In the panel settings, there is definitely a switch from a low signal to a high one.