|
|
I connected DDCS-YL 620 COM- - GND, COM- - XGND, PIN2 (VSO) - VI1, PIN21 (M3) - FWD. set P00. 01 and 07.08 Spindle Works controlled BUT the controller does not work correctly when you run G code, stepper drivers often go into error for no reason, I don't know what's wrong. I turn off the switch to manual control of the spindle, everything is OK. Can you tell me where is the error?
|
|
Posted at 2022-11-4 21:30:22
Favorite