DDCS 4.1 i have a many questions

shurikvas

Hello everyone.
I have a 12-60 machine. 2 motors per y. He worked on a USB board on mach3.
I recently bought myself DDCS 4.1 and there were questions.

1- when turned on, there is an inscription network time synchronization. but nothing syncs and the time starts from 0 each time. and the date is 1-1-1970. Is this normal?

2-When setting up a network connection on windows 10, I see the controller's network drive, but I don't see an open folder on windows10 on the controller. I configured everything according to the instructions. all protocols are enabled, all ports are open. What can be done about it?

3-is it possible on this controller to send any axis to the manually set coordinates? for example, I need the X-axis to move away by 155mm. can I select an axis and set a specific offset?

4- is it possible to see the entire executable code during operation and not just one line?

5-is it possible to implement the home mode when using the A-axis slave with 2 sensors?

6- are there already active users of this controller ready to communicate in telegram?

My telegram +79214390868 (also whatsapp)