Manual tool change

dwafl3

Dear sir I am interested in buy this controler for my build can you tell me if the controller has tool memories for diferent tool legths when you change the tool holder, or tool offset?
can you provide the manual for you most recent firmware uprade?
Regards

Nikolay81

Parameters # 267 - # 282 (H00 tool offset - H15 tool offset) - this is what you need.
In order for them to work, you need to change the tool, using the M6T(tool number)  command . For example, M6T10.
The actions that the machine should take when changing a tool should be described in the module T.nc.
Instructions for all new features are not yet available. It is difficult to update it so often.
People, and so work without days off :-)
But you can help to write it if you know English well.
The values of the new settings, I'll explain to you. Ask what you are interested in.

dwafl3

Hello and tank you for your reply, actually i am from Portugal, but I do well with English i am starting right now building a new machine an look at this controler with great interest, i see that is a quality controller but I am no expert by any means, in Europe I can only find the RMHV2.1 but i believe its the same controller right?

ytliu

dwafl3 Posted at 2018-8-4 05:46
Hello and tank you for your reply, actually i am from Portugal, but I do well with English i am star ...

yes