this is bug?

natsukitanaka

i use firmware 2018-09-07-100
bug1?  can't use tab key.
     boot > push tab key > beep & crash

bug2?  can't use MAXFEEDRATE ＞ It will be ignored. MAX OVER 5000 　（out of step）
     parameterNo77 = 2000
     parameterNo80 = 2000
     parameterNo435 = 2000
     parameterNo436 = 2000

bug3?  don't work homing seq.
     parameterNo49 = 1
     parameterNo50 = 1
     parameterNo51 = 1

     boot > push shift > Z-  > X+
     moove X axis , but switch input ignored.

     My switch is GX-H8A-P (panasonic)

ytliu

You do not need to delete the first line, because the length of this file is greater than 100K, the system will automatically filter out the O command. Only when the file length is less than 100K, the software will scan the program structure of gcode. At this time, multiple subroutines can be defined in gcode, and the system uses O0 as the main program.

I don't quite understand what you said "out of step, over speed". How does it perform? If the machine is stuck and there is a lot of noise, you can lower parameter #99.

ytliu

1.Please set #2028 to a non-zero value, such as 10
2.Please increase parameter #77, such as 6000
3.If you use DDCSV2.1, please use NPN switch, such as GX-H8A

natsukitanaka

Thank you for your reply.

1.solved OK！

2. i try parameterNo77 = 6000
out of step, over speed > 50000
use Fusion360 PostProcessor [fanac G-code]
Is there a solution?

3.solved  OK！

natsukitanaka

G-CODE
[url=]gear_15teeth_fanac.zip[/url]

jjae6

Delete first line 01001