DDCSV slows down when executing G-code

Nikolay81

On the latest firmware, the DDCSV began to slow down and freeze very much when executing complex programs.
Previously, these programs were run normally.
It freezes so much that even pressing the RESET button does not immediately work.
Setting parameter # 2 and # 396 does not help.
The program and my settings - attached.

ytliu

I ran this GCode through your configuration and found no problems.

When GCode runs or the simulation ends, the system will save its length, width and height information. When it is started again, the system will use it to draw the tool path. When this information is incorrectly recorded due to some unexpected circumstances, it may cause you to mention the problem.

You can turn off the toolpath drawing function (#250=0), then run the GCode again. If there are no problems, set #250 to 1 again.