Possible rookie question

dexpiste · Posted at 2019-4-27 09:42:39

First forgive me for my English
Install this firmware and I have a problem, generate two gcode with .tap extension with the Artcam program, the first one is for roughing and the second Gcode is good but it does not run well, it is executed as if it has very small dimensions but the first Gcode runs well.
Why is this happening?

dexpiste · Posted at 2019-4-27 10:00:28

Maybe I have to configure some parameters

alexwalex · Posted at 2019-4-27 13:28:08

Leave here you G-code

dexpiste · Posted at 2019-4-27 23:07:36

How can I upload a file? I do not know how, I try to paste it but it exceeds the bits

dexpiste · Posted at 2019-4-27 23:13:05

I forgot, before when I had mach3 if it worked well.

dexpiste · Posted at 2019-4-28 04:25:13

Well it still does not work, with what extension do you generate the files for this machine? I generate them as G-code (mm) .tap and only the first file works well, that's if I'm new with this machine.
Can you help me?

ytliu · Posted at 2019-4-28 07:48:31

You can send your G-code to me by email, my email address: liuyt7017@gmail.com

dexpiste · Posted at 2019-4-28 09:12:31

Sent, thanks

ytliu · Posted at 2019-4-28 10:05:40

I have received your email.
There must be no spaces in the file name;
What do you mean by "does not work well"?Your G-code specifies F as 18000mm/min. Can your machine reach this speed? If it does, you need to adjust the #77, #78, #79 parameters, as these parameters may limit the actual speed.
Since the dimensions of your G-code is small, you can increase the subdivision of the drive to increase the pulse equivalent parameter.

ytliu · Posted at 2019-4-28 10:09:51

You can run your G-code with a small feed rate, such as 3000mm/min.

Possible rookie question

TEL

0755-87654321