I set X Y Z and A to zero in the controller and using the 54-59 coordinate systems
then run a test nc file which comprises N100 f50.0, N110 G1 X10, only 2 lines.
After pressing "Start" the system moves to X93.65 ,Y126.75, Z -1.357 and
A 6.347 then it moves to X10.
Why does it do this and what do I need to do to stop this?
There are 2 possible reasons the Start Point 0,0,0 is incorrect or the step / mm has an error of 100/93.65 for X 110/126.75 Y Z is not requested to move, therefor check that you have set the home position before you start the sequence
Posted at 2018-12-28 12:03:16
Favorite
Author