Problem with g112

LUCID

Hi
Why DDCSV2.1 does not execute this code
Can someone indicate an error in the code?

N1 %
N2(CAME)
N3
N4(CREATED 06/14/2019 17:57:24)
N5
N6(GRAWEROWANIE - GRAWEROWANIE)
N7 M8
N8 G98 G18 M45
N9 G0 G28 H0
N10(T5 ENGRAVING BIT D 0,1MM)
N11 G0 T0505
N12 G97 S60000 M13
N13 G0 X+14.500 Z+1.000
N14 C0.
N15 G112
N16 G1 F6000
N17 X+5.490 A-2.576
N18 Z-0.200 F200
N19 X+5.998 A-0.892
N20 X+4.562 A-0.459
N21 X+4.165 A-1.773
N22 Z+1.000 F6000
N23 X+4.562 A-0.459
N24 Z-0.200 F200
N25 X+3.126 A-0.025
N26 X+2.618 A-1.709
N27 Z+1.000 F6000
N28 X-2.161 A-2.882
N29 Z-0.200 F200
N30 G2 X-0.445 A-3.721I+0.616
N31 X-1.042 A-5.328I-2.671
N32 X-2.890 A-4.842I-0.783
N33 G1 Z+1.000 F6000
N34 X-3.172 A+0.453
N35 Z-0.200 F200
N36 X-3.620 A+0.973
N37 X-2.772 A+2.524
N38 X-5.264 A+2.879
N39 X-3.620 A+0.973
N40 Z+1.000 F6000
N41 X-2.772 A+2.524
N42 Z-0.200 F200
N43 X-2.092 A+2.427
N44 Z+1.000 F6000
N45 X+1.047 A+3.083
N46 Z-0.200 F200
N47 X+3.039 A+5.326
N48 X+2.575 A+2.900
N49 X+4.929 A+3.647
N50 X+2.937 A+1.404
N51 Z+1.000 F6000
N52 G113
N54 G0 Z50 X0
N55 M1
N56 M5
N57 M9
N58 M46
N59 M30
N60 %
N61

The Z axis is working properly, the X axis is up to a point and it stops. Axis A does not react at all.

ps.
The problem is partially repaired, all the axes are working

Unfortunately, however, it does not work for me G112 code correctly

ytliu

Hi，
G112 is a motion command in DDCS,For milling round pockets.