DDCS3.1 plasmacutter fusion 360 post processor

Teebot · Posted at 2021-10-13 03:19:05

Last edited by Teebot In 2021-10-13 03:27 Editor

I designed and completed my plasma cutter with floating Z head, I connect the float switch to probe and Gnd I use M3/M5 to fire the plasma.

I need help with a postprocessor for fusion-360 that add probing command and M3/M5.

What settings and configuration must I make in the controller also?

babisgr · Posted at 2022-4-28 23:34:47

for spindle (plasma torch in your case) controll there is nothing else...m3 fire the plasma now,its the standard for spindle start/stop

misael · Posted at 2022-10-23 00:45:06

voce conseguiu?

misael · Posted at 2022-10-23 00:45:45

você conseguiu, porque preciso da mesma resposta sua

DDCS3.1 plasmacutter fusion 360 post processor

TEL

0755-87654321