Modify go up z axis

Xartan

Hello


I have a 3.1 panel.

When I execute a gcode in the panel 3.1, the Z axis, goes up 40mm and then goes back down to the start position of the job correctly.

My question is...

- Is it possible to modify it so that it does not go up to 40mm and that it goes up to 20mm the Z axis at the beginning of the job?

DDCSV3. 2DDREAM
SEE: 2019-09-18-112NOR

Thank you

ShaniaDDream

Please check #82 ( page 66), whether you have  set the value here 40mm, perhaps you can change it to 20mm. You can try it first .