Loses lines after a "Pause"

Evgeniy_54

Hi!
The controller DDCSE skips the next few lines of the program after a "Pause" and continues processing from a position far from the "Pause" stop position.
However, at the beginning of the program execution, the controller issued a warning about a line with an incomprehensible code and ignored this line.

Evgeniy_54

Correction. In fact, the controller takes into account the missing lines and starts processing from the point at which the tool should have arrived if all the lines were executed one by one. As a result, the tool moves in a straight line between the stop point and the point of a certain future position. It crashes into the workpiece. Further processing goes without errors.