How to create a logo on DDCSV3.1 Standalone CNC Motion Controller

ViraEQ · Posted at 2021-8-28 20:25:52

Please help me to create a logo when the device is turned on DDCSV3.1

AdaDDream · Posted at 2021-9-13 10:58:56

Last edited by AdaDDream In 2021-9-13 14:29 Editor

Hello Vira, do you have wechat? There is an video I would share with you about how change custom boot logo ddcs v3.1. Or you can leave your e-mail address.

ViraEQ · Posted at 2021-8-30 22:34:50

How change custom boot logo ddcs v3.1

ViraEQ · Posted at 2021-9-13 22:07:21

Thanks for AdaDDream reply
Email : DTMPardis@gmail.com

ViraEQ · Posted at 2021-9-9 00:26:27

There is no one to guide me!!!!!

AdaDDream · Posted at 2021-9-14 09:30:56

Hello Vira, did you got my email yet? If you have any other question,welcome to discuss with me.Thank you!

Saeed · Posted at 2021-9-23 03:47:18

AdaDDream Posted at 2021-9-14 09:30
Hello Vira, did you got my email yet? If you have any other question,welcome to discuss with me.Than ...

Hi can you help me out about changing boot log ?

Saeed · Posted at 2021-9-23 03:50:48

Here is my email saeedvalipour90@gmail.com

AdaDDream · Posted at 2021-9-23 14:22:00

Saeed Posted at 2021-9-23 03:50
Here is my email

OK. I've already sent you an email.

Saeed · Posted at 2021-9-23 15:06:01

Last edited by Saeed In 2021-9-23 15:07 Editor

How to create a logo on DDCSV3.1 Standalone CNC Motion Controller

TEL

0755-87654321