Post processor for DDCS v3.1

MaxF

Hi
I have installed the DDCS v3.1 to control my milling machine. It all works really well in manual mode and via the MPG. I have produced very simple G code written manually and saved as a text file. Using this the controller drove the machine just as I had expected. However, manually writing G code would take to long to mill components. I have designed my components on Fusion 360, and used the post processor to generate g code from the various setups. I looked for DDCS V3.1 in the Post Configuration and couldn't find it. I tried the Linux and Fanuc configurations, but neither of these worked for me. Can anyone advise me what Post Configuration I should use?

Belwect

Hello. Use G-code (mm) (*. tap) or G-code Arcs(mm) (*. tap)

Robchiks

5AXISWORKS or ArtSoft(Mach3mill)

bronzeiro

olá, use um pós processador configurado para mach3, converta ele para usar no fusion.

bronzeiro

olá, use um pós processador configurado para mach3, converta ele para usar no fusion 360

MaxF

Hi
Thank you to everyone for their help. Sorry not to reply sooner, but I have been away for a while.

In the meantime I found this link:
https://brainright.com/2020/10/10/cnccontroller/
Jay kindly provides a post processor which I have now installed and it works really well. it was originally designed for DDCSv1.1, but seems to work well for my DDCSv3.1. Jay advises to check it carefully by doing air cuts. I have found it to work very well.

ShaniaDDream

Manufacturing Post Processor Utility 2017 (64-bit)
We use this post processor.

levesqs

Mach3Mill work directly without modification to gcode