Can the DDSC v3.1 controller work with a lathe?

alexdpol · Posted at 2020-10-12 15:04:10

Hello.
Bought a DDSC v3.1 controller for my lathe. Now there is the latest firmware (2020-03-06-112NOR).

I can't figure out how to do the thread, etc.
You may need to install a special firmware or configure it somehow, please help me figure it out.

Thank you in advance.

JessyChen · Posted at 2020-10-20 09:16:49

DDCS V3.1 cannot do the lathe job.

JessyChen · Posted at 2020-10-20 09:19:14

DDCS V3.1 cannot do the lathe job. DDCS-Expert can do, you can configure one axis to servo spindle, easy.

jorge1969 · Posted at 2020-10-24 05:25:02

Hi,can the ddSc v3.1 run a small plasma table

Can the DDSC v3.1 controller work with a lathe?

TEL

0755-87654321