I just finished setting up my DDCSV2.1 4 axis controller and managed to successfully edit a post processor for Autodesk fusion 360 that will be compatible with DDCSV1.1, 2.1 and most probably 3.1. Also there is some adjustment to calibrate the controller to the 4 axis so you can get exact degrees and avoid over or under stepping.
Anyone need further assistance with this can contact me if needed.
I just finished setting up my DDCSV2.1 4 axis controller and managed to successfully edit ...
Hi yehanv71
I am just this afternoon starting to set up my 4th axis on my newly arrived DDCSV2.1
So the settings you used and the fusion Post Processor would be very helpful
thanks for the offer
Unfortunately, it does not work with 5 axes, in the case of a free license, 600 dollars a year to pay for a garage machine for a license, so that 5 axes would work is not profitable.