|
Ytliu.
I first must congratulate you on the way you have eliminated the added on b/l (backlash) numbers to the display.
This has vastly improved the control unit.
It is good now that what you see on the display coordinates are current with table positions when running nc code.
Thanks again.
Also reading from previous posts, b/l compensation is only active when nc running code, question does this also
includes "probe" ? functions.
So Cont/Step/MPG modes the b/l compensation is not active.
As I currently do not have an accurate probe tool, concentric with the spindle, I cannot use the defprobe in the slib.
I "edge " for home positions off the part to me machined with a "wiggler", basically a tool that rotates with the spindle and has a centrifuge action. it's a typical common machine shop edge finder.
For finding "home or edges" I use the wiggler in conjunction with MPG. ensuring my b/l is in the loaded in the correct direction, but this can get confusing sometimes.
Question for you, is it possible for you to incorporate b/L compensation in the control when using the Cont/Step/MPG, functions, as in this way it does not matter which direction you turn the MPG to set a true home position.
Hope you can understand my question, or maybe any other forum member can help me on this issue.
Best regards, thanks Ytliu and forum members
John
Spain
|
|