|
Last edited by Will_D In 2018-2-26 19:11 Editor
Your Englisdh is much better than my Chinese!!
Thanks for the reply (and also the tool change macro example - will try this out later )
My question is:
If I set parameter #82 to 20.00 (Safe Z retract Height) in my controller, I can then use #582 in my script as it will equal 20.00
If I set parameter #268 to 10.00 (H01 tool offset) in my controller, I can see that #768 in my script is set to 0.00
Will
{UPDATE}
My mistake. I forget to send the M3 command!! Now all works
|
|