Title: PrintNC Sync Two Steppers [Print This Page] Author: cszrwi Time: 2022-2-14 17:15 Title: PrintNC Sync Two Steppers PrintNC uses two steppers and two screws for the Y axis.
I currently have the two drivers connected to the Y axis signal. This does not allow me to home the screws separately to square the gantry.
Is there a solution to this problem? I saw a board mentioned but no details of the name of the board or where it can be purchased?
Please advise what is the best approach.
Many thanks
Rob
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)