Title: DDCSV3.1 Probe menu modification [Print This Page] Author: dmitrijk Time: 2021-11-27 22:11 Title: DDCSV3.1 Probe menu modification Dear developers, can I ask you to add the ability to change the code for the probing modes shown in the picture ("X+:x 1/2" & "Y+:y 1/2")? I think these modes are used very rarely. Instead, we could ourselves add, for example, finding the center of a pocket or hole . Thanks in advance!
Author: AdaDDream Time: 2021-11-29 11:28
Thank you for your feedback ！Author: dmitrijk Time: 2021-12-1 04:18
Do we have any hope that you will make changes to the firmware?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
