Digital Dream Technology support

Title: G110 Rectangular pocket works or no? [Print This Page]

Author: markm2040 Time: 2021-11-16 10:59
Title: G110 Rectangular pocket works or no?
I don't seem to have any luck with the rectangular pocket.
The circular pocket works and is great with the following

(inches)
G17
G90
G1 X1.800 Y5.777 Z-2.0 F50
M3 S18000
G111 I1.0 Z-4.1 R0.125
G111 I1.0 Z-4.2 R0.125
G111 I1.0 Z-4.3 R0.125
G111 I1.0 Z-4.4 R0.125
G111 I1.0 Z-4.5 R0.125
G111 I1.020 Z-4.5 R0.125
G111 I1.020 Z-4.5 R0.125
G1 Z -3.00
M5
G0 Z-1.0 X0.0 Y0.0
M2

But I cannot get the G110 to work at all. It makes one pass, not really following good lines, then the command ends.

badpocket.jpg (377.5 KB, Down times: 319)

not a great outcome

Author: markm2040 Time: 2021-11-16 11:00
I know. The plunge was way too deep, but I still would expect some ... idk ... pocketing.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)