Title: I can't reduce F speed in G code. [Print This Page] Author: yusufçelik Time: 2021-10-25 19:35 Title: I can't reduce F speed in G code. I cannot lower the F speed in the DDCS V3.1 control panel. Since the drill bit I use is at the micron level, I need to use the F speed as 1.8 units when drilling holes. But even though I wrote F1.8 in the G code, it breaks crochet because the F value does not fall below 3 automatically. Please help me with this. Author: boy_s Time: 2024-9-17 11:09
Can you solve this problem. Now I have same problem with slowly g-code feedrate. I want to run feedrate 0.02-0.18 mm/min but DDCSV3.1 can show feed at only 1-3 . I test run F0.02 and F0.18 mm/min .Cercle time is same.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
