Title: M98 Subroutine was not found [Print This Page] Author: matthias.frei Time: 2021-10-12 17:26 Title: M98 Subroutine was not found I've tried to write the subroutine in the main file (as below) or place it in a separate file (O111.nc), but nothing works.
Has anyone ever had success writing macros for a DDCS-Controller?
O000
M98 P111 L3
M30
%
O111
G91
G01 A10.00 F500
M99
%Author: mateusz9006 Time: 2021-11-4 15:17
Hi everyone, sorry for my english.
When I wrote my macro, I also had this problem. The solution was to add a semicolon ";" after the macro call line.
M98 P111 L;Author: alismont Time: 2021-12-3 21:02
Cela ne fonctionne pas !!!!Author: cornelio Time: 2022-9-21 06:54
Hello, i have the same issue, did you fixed?Author: cornelio Time: 2022-9-21 06:55
Hello, i have the same issue, did you fixed it?Author: AlexSid Time: 2023-7-14 10:11
O00001
M98 P111 L3
M30
%
O00111
G91
G01 A10.00 F500
M99
%
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)