Digital Dream Technology support

Title: DDCS V3.1 WILL WORK ON LATHES!! [Print This Page]

Author: gmillwater Time: 2021-9-24 22:14
Title: DDCS V3.1 WILL WORK ON LATHES!!
Thanks to the help of Jessy Chen, the problem with Z axis on lathes has been resolved. If you have tried using this on a lathe, you will run into a problem with your Z axis. The Z safety zone needs to be set to a negative value to allow the Z axis to move towards the spindle. Factory firmware won't allow this.
Contact Jessy and she'll hook you up with a firmware upgrade.
Thanks Jessy for solving my problem!!!

Author: AdaDDream Time: 2021-9-27 13:32
Thank you for your feedback.

Author: leo121 Time: 2021-10-23 20:26
from whom can I get this Firmware-Upgrade

Author: AndreyB Time: 2021-10-24 16:08
I think better way - disable ddcs safe Z move. Its also actually for milling.
To disable ddcs safe Z move, delete /mnt/nand1-1/safez.nc

Author: leo121 Time: 2021-10-25 06:35
ok, there is no spindle feedbak for thread or index, I hope to change a firmware in the future toget an input for the spindle.

Author: AdaDDream Time: 2021-10-25 15:20

leo121 Posted at 2021-10-23 20:26
from whom can I get this Firmware-Upgrade

Dear Sir, please find the attached file.
Decompress it to the root directory of the USB-key.
Insert into the controller, and restart the controller.
System will update it automatically.

At the same time,only the "insert" file can be stored in the USB flash drive.http://www.ddcnc.com/index.php?m ... 440bb43&lang=cn

Author: AndreyB Time: 2021-10-25 19:00
Last edited by AndreyB In 2021-10-25 19:29 Editor

ok, there is no spindle feedbak for thread or index, I hope to change a firmware in the future toget an input for the spindle.

Topic starter, doing funny trick with change spindle motor to stepper motor, every time when need threading. Stepper controled like A axis. He upload video, but i cant find link.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)