Title: Tool compensation question [Print This Page] Author: Cosmosukr Time: 2021-6-17 18:17 Title: Tool compensation question First of all, how one can input "D" letter on "edit program" mode? There is no "D" on the virtual keyboard.
I tried to make diameter compensation (parameter #420, for example). I added G42 D01 in NC-file (T1 M06 G42 D01) but controller fell into ERROR message. I tried to input in different ways but result is the same. What I do wrong? How should I make diameter compensation?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)