Title: End of career [Print This Page] Author: Enfama Time: 2021-6-8 06:02 Title: End of career I have installed the 6 limit switches for the XYZ axes. In manual form they work correctly. The GOTO-0 also runs perfectly and pulls back based on the measurement set to # 83, # 84, # 85. But in automatic mode when executing a G-code file, when looking for the start position and activating the limit switch, it activates the alarm beep and executes a Reset and locks the system, which forces it to exit the automatic system.
Could you tell me what parameters I have to modify so that when I activate the end of races it goes back the same as in the GOTO-0 and takes the position with Home or start ???. Author: Tecnocnc Time: 2021-7-18 22:33
LIMIT SWITCH AND HOME IS THE SAME SWITCH?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)